Thundermodel plastic scale model | Bergepanzer 38 Hetzer Late

Products US Heavy Wrecker LaFrance M1000 series 2 US Army Case tractor 1-72 LRDG F30 Patrol Offset Bed Bonus LRDG F30 Patrol Offset Bed Standard LRDG F30 Wireless Truck Bonus edition LRDG F30 Wireless Truck Bofors 37mm AT Gun LRDG F30 Gun Truck LRDG F30 GunTruck Bonus edition US Clarktor6 Mill44 Tug LRDG Figure sets LRDG Weapon Sets LRDG F30 Patrol Truck Bonus edition LRDG F30 Patrol Truck US Army Bomb Trailer Mark2 US Clarktor6 with bomb trailers British Morris C9/B Gun Truck Early US Clarktor6 Mill33 Tug German Bergepanzer Hetzer with 2cm Flak Russian ChTZ S60 Stalinetz British Morris C9/B Gun Truck Late German Ssyl Flat Wagon German Kesselwagen US Crawler Sixty German APV Katzchen German Gedeckter Guterwagen Gr 15t German Gedeckter Güterwagen US Military Motorcycle Indian 741B British 7_2 inch howitzer Canadian 20 CWT GS Trailer Scammell Pioneer SV 2S recovery tractor Scammell Tank Transporter Goose Neck Scammell Pioneer R100 artillery tractor Scammell TRMU30 TRCU30 Tank Transporter German Baureihe BR80 Bergepanzer 38 Hetzer Early Bergepanzer 38 Hetzer Late US Army Tractor Case VAI US Army Loader

Bergepanzer 38(t) Hetzer Late

Bergerpanzer 38(t) was a recovery vehicle based on Hetzer’s base, with lower open-top superstructure, manufactured by BMM company in Prague. The plans were approved in September 1944 and called for production of 170 vehicles until the end of 1944. In fact just 101 vehicles were built. To meet the production plans it was decided to convert 64 summer production´s Hetzers into armoured recovery vehicles, but it is unknown how many were actually converted. Production was much slower than plans, and total number of about 180 vehicles was finished until the end of the war.
The Bergepanzer was equipped with two-ton folding jib crane used to handle engines and other heavy components. Additionally the recovery vehicle was equipped with five-ton winch of Baumgarten company. The winch was driven by the vehicle´s engine through transmission system. At the end a blade was installed at the rear of the hull, but it is again unclear how many vehicles were equipped with it. There were also some development works to install the blade at the front of the vehicle, as seen in the company blueprints, but probably these plans were never realized.